Meet Our Acrylic ChillerUpdated a day ago

Acrylic Chiller 0.6HP

Designed specifically to pair with the Acrylic Tub, the 0.6HP Acrylic Chiller brings mid-range power and WiFi connectivity to a premium fixed installation. More powerful than the X2, with faster cooling and higher volume capacity, it's built for a setup that's meant to stay put.

Recommended use: Acrylic Tub use only.

Specifications

Acrylic Chiller 0.6HP Original

• Compressor: 0.6 HP
• Cooling: Down to approximately 3°C
• Filtration: Internal rear mesh filter + external 20-micron cartridge
• Connectivity: WiFi (TUYA Smart app, 2.4 GHz only)
• Power: Standard 10A outlet

Acrylic Chiller 0.6HP Pro (all Original specs, plus):

• Large top-mounted filter cup with replaceable 20-micron cartridge
• Three-stage filtration: ozone + internal mesh + 20-micron cartridge

What's in the box

Original: 

• Chiller unit 
• 2 x insulated hoses 
• External 20-micron filter housing 
• Power cable

Pro: 

• Chiller unit 
• 2 x insulated hoses 
• Top filter cup assembly with 20-micron cartridge 
• Internal mesh filter 
• Power cable

Cooling time

Typically 4–6 hours for standard ice bath volumes, depending on water volume and ambient temperature.

Setup

1. Position the chiller on a stable, level surface adjacent to the Acrylic Tub.
2. Connect the inlet and outlet hoses to the fittings on the tub before filling.
3. Fill the tub to the recommended level (5–7 cm below the rim).
4. Connect to power and download the TUYA Smart app on a 2.4 GHz network.
5. Set your target temperature via the app or unit controls.
6. Allow 4–6 hours to reach your target temperature.

Pro model: ensure the top filter cup is correctly seated and secured before first use.

Settings

• P1: Temperature hysteresis (default 2°C)
• P2: Compressor start-up delay (default 3 minutes)
• P3: Display toggle between °C and °F

Pro model: if you receive an E2 water flow error, check and clean the top-mounted filter cup first. This is the primary troubleshooting step specific to the Pro variant.

Benefits of this model

• Faster cooling than the X2 at the same power draw
• WiFi app control for remote monitoring and scheduling
• Pro variant's three-stage filtration significantly extends water clarity between changes
• Designed to complement the Acrylic Tub as a permanent installation pairing

Setting the scene

The Acrylic Tub sits in the corner of your home gym. It's always filled, always at temperature, and it looks the part. After a training session you drop in without having to prep anything. The chiller has been running quietly in the background, holding your target temperature overnight. You check the app on your way from the weights to the plunge, see it's at 12°C, and adjust it to 10°C for tomorrow. The Acrylic Chiller is for the person who wants a permanent, polished cold plunge setup at home, where the experience starts before you even get in.